memerase.
ColorWall Technical Specifications.
| Total Wt. at 60" |
33.3 oz./lin.yd.
1032 g./lin.m
|
| Total Wt. |
20.0 oz./sq.yd.
678 g./sq.m
|
| Fabric Wt. |
2.6 oz./sq.yd.
88 g./sq.m
|
| Vinyl Wt. |
17.4 oz./sq.yd.
590 g./sq.m
|
| Tensile |
160 x 170 lbs.
712 x 756 N
|
| Backing |
Polyester Drill
|
| Elmendorf Tear (warp x fill) |
82 x 89
|
| Average Thickness |
23 mils (0.023"), 0.584 mm
|
| Fire Resistance (ASTM E-84) |
Class A
|
| Gardner Gloss (60°) |
80
|
| Adhesion (vinyl to fabric) |
3.0 lbs.
(13.4 N)
|
| Spec Colorfastness (200 hours) |
Pass |
Fire Resistance
memerase® ColorWall™ surfaces meet Federal Specification requirements of G.S.A. CCC-W-408A,B,C,D and the CFFA-W-101-B Quality Standard for Vinyl Coated Fabric Wallcovering. This material has been tested for fire hazard classification in accordance with ASTM E-84 Tunnel Test on reinforced cement board.
*NOTE: The numerical flame spread rating and other test results referenced herein are not intended to reflect hazards presented by this or any other material under actual fire conditions. Due to increased fire hazard, OMNOVA Solutions does not recommend the installation of its products (excluding borders) over previously applied vinyl, paper or fabric wallcoverings. Consult an architect or fire safety engineer for information on applicable building codes and reduction of fire hazards, including the use of sprinklers.
Physical Properties
memerase ColorWall surfaces satisfactorily pass physical requirements for Type II as listed in G.S.A. Federal Specification CCC-W-408A.
memerase ColorWall surfaces are PFOA-free: They do not employ any materials that contain or that can degrade to Perfluoro Octanoic Acid (PFOA), a compound that may present potential health and environmental risks.
Stain Resistance
(ASTM D-1308, METHOD B-24 hour exposure followed by washing with soap and water.) The following staining agents resulted in NO STAIN on the material when using the aforementioned test method:
| Ethanol |
Pencil |
Hydrogen Peroxide |
| Vinegar |
Mayonnaise |
10% Sodium Hydroxide |
| Detergent |
Bleach |
Oleic Acid |
| Lemon Juice |
Crayon |
Port Wine |
| Coffee |
Ketchup |
10% Ammonia |
| Tea |
Cola |
Milk |
Cleaning Procedures
The memerase surface should be washed to remove all adhesive residue with warm water and thoroughly dried with a dry, soft cotton cloth prior to initial use. Common dirt and stains may be removed from the memerase surface with the use of water and a dry, soft cotton cloth. It is important that clean water be used on a consistent basis and that the material be dried thoroughly.
CAUTION: Use of strong organic solvents and harsh abrasive cleaners may cause dulling, discoloration, and/or softening of the vinyl or the coating, causing permanent damage, and will invalidate the warranty. For complete cleaning instructions, see:
memerase Standard Care and Maintenance Instructions
Surface Preparation
Proper surface preparation is essential for a quality installation. Any wall imperfections or irregularities will be noticeable after the memerase surface is installed; the wall surface must be prepared to a Level 5 specification. For further information, please see the memerase Installation Instructions.