memerase.
ProjectionWall Technical Specifications.
| Width |
60" |
| Total Wt. |
27.0 oz./lin.yd.
837 g./lin.m
|
| Total Wt. |
16.2 oz./sq.yd.
550 g./sq.m
|
| Fabric Wt. |
2.6 oz./sq.yd.
88 g./sq.m
|
| Vinyl Wt. |
13.6 oz./sq.yd.
461 g./sq.m
|
| Tensile |
172 x 176 lbs.
765 x 783 N
|
| Backing |
100% Polyester
|
| Elmendorf Tear (warp x fill) |
100 x 100
|
| Average Thickness |
20 mils (0.020")
0.584mm
|
| Fire Resistance (ASTM E-84) |
Class A
|
| Gardner Gloss (60°) |
<60
|
| Adhesion (vinyl to fabric) |
3.0 lbs./in.
(13.4 N)
|
| Spec Colorfastness (200 hours) |
Pass |
Fire Resistance
memerase® ProjectionWall™ surfaces meet Federal Specification requirements of G.S.A. CCC-W-408A,B,C,D and the CFFA-W-101-B Quality Standard for Vinyl Coated Fabric Wallcovering. This material has been tested for fire hazard classification in accordance with ASTM E-84 Tunnel Test on reinforced cement board.
*NOTE: The test results referenced herein are not intended to reflect hazards presented by this or any other material under actual fire conditions. Due to increased fire hazard, OMNOVA Solutions does not recommend the installation of its products (excluding borders) over previously applied vinyl, paper or fabric wallcoverings. Consult an architect or fire safety engineer for information on applicable building codes and reduction of fire hazards, including the use of sprinklers.
Physical Properties
memErase ProjectionWall surfaces satisfactorily pass physical requirements for Type II as listed in G.S.A. Federal Specification CCC-W-408A.
memerase ProjectionWall surfaces are PFOA-free. They do not contain, nor will they degrade to Perfluoro Octanoic Acid (PFOA).
Stain Resistance
(ASTM D-1308, METHOD B-24 hour exposure followed by washing with soap and water.) The following staining agents resulted in NO STAIN on the material when using the aforementioned test method:
| Ethanol |
Pencil |
Hydrogen Peroxide |
| Vinegar |
Mayonnaise |
10% Sodium Hydroxide |
| Detergent |
Bleach |
Oleic Acid |
| Lemon Juice |
Crayon |
Port Wine |
| Coffee |
Ketchup |
10% Ammonia |
| Tea |
Cola |
Milk |
Cleaning Procedures
For best performance, memerase surfaces should be cleaned on a regular basis - daily if necessary - depending upon use. As with any dry erase surface, residue may build up on your board over time. If erasing becomes difficult, clean your board thoroughly.
The ProjectionWall product will require more frequent cleaning than the WhiteWall product and should always be cleaned with dry erase cleaner.
CAUTION: Use of strong organic solvents and harsh abrasive cleaners may cause dulling, discoloration, and/or softening of the vinyl or the coating, causing permanent damage, and will invalidate the warranty. For complete cleaning instructions, see:
memerase Standard Care and Maintenance Instructions
Surface Preparation
Proper surface preparation is essential for a quality installation. Any wall imperfections or irregularities will be noticeable after the memerase surface is installed; the wall surface must be prepared to a Level 5 specification. For further information, please see the memerase Installation Instructions.